Overview
Confirm the substrate, framing, services, waterproofing design, finish weight and fixing method before cutting or fixing boards.
Key points
- Structurally sound, dry and stable
- Clean and free from dust, oil, release agents and loose material
- Flat enough for the selected fixing or adhesive method
- Framing plumb and secure; sheet edges supported
You'll need
- Tape measure, straight edge and level
- Utility knife, handsaw or circular/track saw
- Hole saw or multitool for penetrations
- Driver and corrosion-resistant screws
- Caulking gun for Thermasheet MSP Sealant
- Dust extraction and PPE
Installation steps
-
1
MEASURE AND MARK
Measure and mark accurately before cutting.
-
2
CUT
Thin boards may be scored and snapped; thicker boards are generally quicker to cut with a fine-tooth saw or circular/track saw. Use dust extraction where practical, and wear eye protection and a particulate mask when power cutting.
-
3
DRY-FIT
Dry-fit boards before applying adhesive or sealant.
-
4
PROTECT EDGES
Keep factory-coated faces intact where practical. Protect exposed cut edges in wet or external work as required by the installation detail.
